![]() |
|
General Fat Chance Discussion Anything and everything about the best mountain bikes ever made. |
![]() |
|
Thread Tools | Search this Thread | Display Modes |
![]() |
#1 |
Member
Join Date: April 25th, 2007
Location: hyattsville
Posts: 50
|
![]()
Hello Help. I need advice on Replacing Press-In Bottom Bracket? Thanks
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: July 16th, 2004
Location: Netherlands
Posts: 638
|
![]()
Hi mediascapegoat,
You can contact Rody for brand new stuff ![]() http://www.fatcogs.com/forum/showthread.php?t=1114
__________________
Melvin Yo rider, Wicked attitude |
![]() |
![]() |
![]() |
#3 |
Senior Member
Join Date: February 16th, 2007
Location: Durango, CO USA
Posts: 167
|
![]()
I just did one. It was my virgin experience so I was careful and slow
![]() I have a makeshift headset cup press. Basically its a long threaded shaft with two big washers and some nuts. The washers were the perfect size for the Fat BB bearings, and I just worked them in slowly. Remember, if its not going in exactly flush, it may not go in at all 'cause they fit so tight. Mind the sexual overtones here. |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: April 25th, 2007
Location: hyattsville
Posts: 50
|
![]()
Thanks for the reply made my day, seriously post a picture.
|
![]() |
![]() |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | Search this Thread |
Display Modes | |
|
|