Thread: Hubs
View Single Post
Old January 25th, 2006, 10:09 PM   #8
Senior Member
rody's Avatar
Join Date: October 19th, 2005
Location: Wooster, Ohio
Posts: 288

All right Tony, since the folks at Phil won't play nice, do what I did....

Order the hubs from Phil, press out the bearings, and send the shells to Randy and Travis at Absolute Finish.

These guys will custom ano the hubs for you. Their minimum order is 45 bucks, but in the end, if this is what your project needs, to hell with the cost

Check them out at

Good luck with the project,

Groovy Cycle Works
rody is offline   Reply With Quote